Do Rows Count as Biceps Sets? How to Log Rows and Curls
Yes. If you bend your elbows against a challenging load during a row, your elbow flexors do some of the work. For a weekly biceps tally, a useful starting convention is to log each hard curl set as one direct set and each hard row set as half a set. Keep the two numbers separately in your log. Six sets of rows and four sets of curls give you four direct sets plus six pulling sets, or about seven sets under that convention.

What did rows and curls actually do in training studies?
In an eight-week experiment, ten untrained men trained one arm with dumbbell rows and the other with curls. Elbow-flexor thickness increased with both exercises, with a larger increase on the curl side. The researchers measured the muscles that bend the elbow together. Their measurement cannot tell you exactly how much the biceps alone grew. Read the Mannarino study.
A later experiment helps explain why a fixed conversion factor is tricky. After eight weeks, the curl and row arms showed similar changes at the upper measurement site. Closer to the elbow, the difference favored curls. Only nine untrained men completed that training experiment. Applying one ratio from either study to every row machine, grip and experienced lifter would stretch the evidence. See the regional measurements from Leitão and colleagues.
How to count a row in your own log
First decide what you want the number to answer. If you want to know whether you practiced curls twice this week, count curls. If you want to know how much work your elbows are recovering from before tomorrow’s curls, include pulling. A meta-regression by Pelland and colleagues compared giving indirect work zero, half or full credit. Half credit was the best-supported convention across the studies they pooled. It gives you a consistent estimate when comparing weeks. Read the dose-response analysis.
- Hard dumbbell or cable curl: log one direct set. Make a note of load, reps and how many clean reps you think remained.
- Hard row with appreciable elbow bend: log one pulling set. Give it half credit in the biceps estimate. For a one-arm row, three sets on each side means three sets per arm.
- Warm-up or straight-arm pulldown: leave it out of this biceps tally. A straight-arm pulldown can be demanding for your back while the elbow angle barely changes.
Two upper days, counted once
Suppose Monday has three sets of chest-supported rows and two sets of incline curls. Thursday has three sets of cable rows and two sets of preacher curls. You have done ten working sets across those exercises. Your biceps estimate is 2 + 2 + (3 + 3) × 0.5 = 7. If you want to repeat the calculation for a different week, enter four direct sets and six indirect sets in the training volume calculator. It applies the half credit for you.
| Session | Row sets | Curl sets | Biceps estimate |
|---|---|---|---|
| Monday | 3 | 2 | 3.5 sets |
| Thursday | 3 | 2 | 3.5 sets |
| Week | 6 | 4 | 7 sets |
Now replace Thursday’s rows with three sets of straight-arm pulldowns. Your back still has a pulling exercise. Your estimated biceps volume falls to 5.5 sets, even though the session is just as long. This is the kind of change the tally is good at spotting.
Should you add curls if you already row?
If your curls are progressing at the same point in the workout and your arms feel ready for the next session, keep the routine long enough to see a trend. If biceps are a priority and your entire log consists of rows, try replacing one accessory slot with two sets of curls. Keep your row setup steady and record the curls for several sessions. You now have a direct measure of elbow-flexion performance as well as the pulling work.
If your curl reps drop immediately after you add more rows, repeat the comparison with the same exercise order before adding sets. A curl performed after six hard pulling sets is a different test from a curl performed first. The four-day upper/lower guide shows where those slots fit across a week.
Frequently asked questions
Do three sets of one-arm rows on each side count as three or six?
Each arm did three sets. If you give rows half credit, log 1.5 estimated biceps sets per arm. Adding left and right together would double the volume attributed to each arm.
Can I count one row set for both my back and my biceps?
Yes, when you keep separate totals for each muscle group. In your session log it is one working set. In this example it contributes one pulling set to your back log and half a set to your biceps estimate.
